Ninja (Noongari) smoke

Woke up with a congested nose and after a while the place filled more with smoke. I went outside and again found some tiny one inch tall volcanoes under the siding. After i flattened those, tried to air the room but i think dirty socks smell comes from the wind's direction. After about ten minutes, smoke (different, probably kratom) is again filling the room. Going to the park. Hospital alleys. Whatever.

9:28 They speculate differences in perception. To me it's obvious what's happening. To most, they don't understand what i'm saying. What tiny volcanoes? Have he lost his mind this morning, again?

Everybody living in a house in the US has at least on bathroom fan. Ever wondered where the air sucked from the bathroom goes? Behind the fan, inside the ceiling (upstairs floor) there is a 3 or 4 inch flexible pipe or hose (flexible during installation, actually it never moves, for decades after) that goes through an (empty) wall all the way to the top of the roof. Made of a thin aluminum foil, with a coiled wire to make the shape, or something similar. It is not one piece from bathroom to roof. Pieces are joined with duct tape. Tape in time becomes hard and sometimes most of the times the pipe will leak at joints, inside walls. More or less. In time it also builds inside about half inch of dust on the thin foil. That may backflow in your bathroom, depending. Vibration, air flow. Airflow leaking from other pipes from other apartments, building pressure inside walls and inside your pipe. And had lots of that. Until:

I put on top of the regular bathroom fan a tiny computer fan that works continuously at lower than normal voltage (about 6 volts instead of 12) and ensures at least it does not backflow as it did. When the big fan starts, air flows through the small one, accelerating it. When it doesn't the small fan pushes constantly a small amount of air. But even if it didn't, due to regular thermal flow (warmer air goes up), some air will bypass the one way valve in the fan's box and flow upwards.

During drying. Vast amounts of air are being sucked from inside the room and pumped outside. Regular houses have driers installed in garages or other special rooms. But if it's not the garages, will suck air from where inside the house.

Believe it or not. Main fresh air supply inside a house comes from under main or back or garage door, washing the sills of those doors, one of the dirties places inside a home.

But there is another source. Walls are not sealed in most American houses. There is a big half inch gap between the "drywall" and the floor, other gaps and cracks, around windows, appliances, cabinets, etc..

Air goes in and out the wall depending. Some air from outside will bypass the siding (especially at bottom or where the siding starts) and cracks inside the walls.

And here comes the diagram of thermal air flow around a house. Cold weather here includes during night, evening and mornings, where house walls temperature is higher than outside air. All passive, high science, low teck, ancient knowledge.It's all self explanatory. If you stick (during let's say a casual dog walking) something burning inside the ground close enough to the building (most of the "recipes" in Basenshukai, or the book of  ninja, contain saltpeter, that has oxygen in the formula, other oxygen locking chemicals, saltpeter was not available in Japan when the book was written, and burns underground) the smoke, due to the pressure created by the laminar thermal flow will bypass the siding and the walls and get inside. Most of it will not get inside, but flow upwards around  the building and up in the sky and will not be perceived by bypassers. Since build up of concentration inside is gradual, the occupants will get used and after a while will start to change mood, feel happy, worry free, forget things, take weird decisions, etc..

And if you open the main door, smoke will come out, exactly like if the occupants themselves where using it, for all bypassers to smell. You will have it in you system, clothes, etc..

I apologize if the post is not 100 well formulated and concise, i am under influence, big time this morning, cause they are behind and getting really mad as more of their secrets (and deeds) are being revealed, everyday and pushing it big time on me.

Had plans for this morning, wanted to order online OEM axles for the car, can't do anything, can't concentrate, afraid not to order the wrong ones.

November 13

12:11/10:11 Adio și n-am cuvinte...

11:59 Look like the manager at Autozone store on Dartmouth St where i bought the second shaft and returned it yesterday (she had a mask and not easy to guess, but the eys). He looks like the customer with bass voice and of course mask.

1:13 Another hour of my life. I can't sing like that. You can't sing like that. Nobody can sing like that without decades of professional voice training.

1:14 I noticed lately lots of people rushing me to do things. Sometimes just by example. Sometimes just a rushed smile. I called it rush entraining. Beautiful bullies who teach us to follow impulses. In that day or the day after, two train related accidents happened, one in Britain and one in Japan.

1:23/11:23 Urmând "dezvăluirii" secretelor din legea plafoanelor, adică mărimea bugetului (400 miliarde), numărul de bugetari (peste un milion), salariile acestora (109 miliarde), alte informații preluate din această lege, un număr de publicații din România promovează un zvon. Nu se poate fiindcă marea majoritate a bugetarilor sunt profesori, medici, polițiști și militari.

4:51

5:29 Wandjina, wadget, djin, nagas, whatever...

The New Car Story

It looks like i got no other choice but write the car story. In the first day or 10/13 when i went to see the car, i tried to drive it @ to see if there's anything wrong with it on a total distance of maybe a quart of a mile. There was a splash guard touching the tire on the front left side, or where the wheel has been hit. There was a clunking sound on the right side. I briefly put the car on a jack with the help of the guy in the body shop who gave me tools and i looked and saw the right CV shaft (passenger, longer) was bent, in the rush of events at first i thought it was just wobbling (knew it was not hit on that side in the recent accident) from articulations when turning the hub by hand, only realized it was bent weeks after or on 11-08, when i also realized there is nothing on my car that could have caused those abrasions.

Went the next morning at AutoZone on Dartmouth St and picked one for 150. It seemed a good deal, but when i put it on i saw it was 30% thinner then OEM one. One of the consequences of being thin is it twists maybe half turn when i put the car in drive or rear. Also when i drove it a few days ago on I5 to Wilsonville to test the mpg, i heard a vibration. I raised the car on the jack and saw the newly installed Autozone shaft got a big play at both ends. First i tried to order a used one at B&R for 65 bucks and Wednesday i went to North Portland to pick it, but was damaged and rusted and refused it and asked for a refund. In the same day i ordered another one at Autozone, similar with the one that's on on the right, just to measure it. With a cheap caliper, by comparison only, it seemed smaller than my bent OEM (they probably use looser tolerances than OE manufacturer), both the outer diameter in the splines area and distance between 5 teeth. I measured it like 20 times just to make sure and returned it though there was this annoying music in the store, people talking aloud, overwhelmingly overly polite, etc.. Now i'm trying really hard to find both shaft online as OEM parts. I found them on a site for 250 each but now i sit and wonder if the site is legit (here at dealerships is between 380 and 400 a piece, it is true, on the same site the Korean built ones are 330+shipping, my car is US built). On driver side again there is a badly rusted one which could not have been only 4 years old with no other rusted parts on the vehicle. Now i remembered i asked the guy at the store (who is not a mechanic but did some struts replacement in the past why the shock absorber is not in the middle of the spring, he said because the car is on a jack and spring is extended all the way, can't wait to go and take a picture now that the car is on wheels.

Never touched the left shorter rusted axle.

It is for the first time that i realize that the strut is also bend towards the end.

By comparison with the one on the passanger side, with the much thinner (Autozone) shaft which is still on the car, is seems this one is bent

Today i got called again by the guy at B&R (the same voice as the 855 number) and he told me the part (again right shaft, OEM, used) is waiting for me in North Portland, i told him i went there two days ago and refused it, again for being rusted and one of the boots popped in and making a sound when rotating that end.

Got the number for B&R from a guy from Hillsboro Auto Wrecking. I went there for a hub (at the time i believed the noise coming from the front wheels is from a bearing). The bearings had too much of a play and the hub was rusted so i just drove back there and returned it. In that day i drove more than 100 miles for that hub.

11:00 13 On November 4 in the evening i went to pick the car. Drove it here, took Angela with me (both had very little sleep the night before), drove back over there to pick the truck. Both in the car, we agreed that there was a weird smell. We stopped at an Autozone store and bought an engine air filter and a cabin air filter. I replaced the engine air filter in the parking lot, but when i tried to pull the cabin air filter (the one on top of the fan), a couple of pounds or more of rancid dog food came with the filter, some falling on the car's floor, most in the fan. So we went to a carwash (a mile away next to O'Reillys), tried to vacuum but the hose would not go in the place where filter was. Finally vacuumed enough of those for the fan to work. Went to pick the truck, Angela drove the car home. Next morning, after i wrote about the whole story i went to Lowes to pick a dishwasher drain hose to adapt to the vacuum cleaner. I dropped the blower fan and with one more shorter flexible hose on top of that, i went and picked the remaining pellets from the heater core housing.

The only way that dog food could have gotten in there was by removing the grill (between hood and windshield) from outside. I felt that smell in the first day i went to see the car or when i discovered the CV shaft on right side was bent. While i was vacuuming, the guy upstairs came and parked in his spot next to me. It was then when i asked him if he ever cleaned the filter of his drier and he seemed puzzled. I explained to him how to do it. After that he stopped using the drier altogether but he started again and i looked and the flow of the steam from the vent is very low and he just restarted drying the same load.

November 12

1:49/11:49 Repertoriul legislativ 2021

November 11

5:57/3:57 Mi se pare ilogic. Spitalul nu avea autorizație de securitate la incendii (ASI) nici/de pe vremea lui. Sau a lui Mihăilă. O singură întrebare de ministru totuși. Câte spitale încă nu au această autorizație? În media se spune că asta se poate întâmpla oricând, în orice spital. Chiar dacă guvernul e demis, remember, miniștrii încă asigură interimatul  sau interimatul de interimat (un ministru demis și interimar la Dezvoltare, altă gaură neagră pe lângă Transporturi, care asigură interimatul la Sănătate). Asta înseamnă că nu fac nimic, doar ocupă funcția, doar iau salariu, decorativi, nu? Fru_moșii miniștri ai marilor găuri negre?

9:29/7:29 Conturarea

9:32/7:32 Subsemnatul,...

9:58/7:58 Primul Ministru nu cere, că nu are cui, nimeni nu e mai sus decât el, el ia decizii. Iohannis e doar un mediator. Și mai contrasemnează legile emise de Parlament. Și mai numește și desnumește procurori, judecători și prim miniștri. Cât de greu era/încă este pentru Cîțu să semneze o decizie prin care toate spitalele să fie controlate, puse la punct și aprobate cu ASI? Vine acum în media și spune că a cerut? Normal ar fi să-și dea demisia, dar nu are cum fiindcă e deja demis, remember?